Appliance Types


Appliance Brands


Article Categories


More Articles


Pool Heaters Troubleshooting
Pool Heaters Troubleshooting

Pool Heaters Troubleshooting

A pool heater takes water from the pool and takes it to a heating tank that sends warmer water back into the pool. This is an exchange of cold and warm water that keeps your pool at a comfortable temperature, even if it is cold outside.





Check The Power:
When you are working on troubleshooting a pool heater, one of the most common culprits is the power source. Sometimes the fix can be as simple as making sure the pool heater is plugged in properly. 

Examine Error Codes:
If you find that your power heater turns on but then keeps shutting off, this could indicate that you are having water pressure issues. Your first step would be to take a look at any error codes that might be displayed. 

Examine Power Sources:
If you do not see an error message and instead, your pool heater just shuts off immediately after or shortly after turning it on, then this can be an indication of a power issue. In this case, you will want to check your power sources and connections to make sure everything is as it should. Checking the breaker, resetting the unit, and going over connections is the step you will want to take. 

Check The Temperature Settings:
Most pool heaters are incredibly temperamental when it comes to the temperature you set it at and the outdoor temperature. If your pool heater is not set to a high enough temperature, then it may not appear to be working (though it’s working just fine). 

Check Your Outdoor Temperature Settings:
With some pool heat pumps, if it is not warm enough, the heater will not run and keep up the water. There are different types of pool heaters, including gas and electric heaters, that will work just fine during cold weather, though some operate better than others. 

Check The Filter:
If your pool heater is not getting enough water, then this could cause it to be faulty. Pool heaters rely on a steady stream of water in order to operate properly, and when this is interrupted, you will start to run into issues. To make sure that your pool heater is getting enough water, you need to check your filter. If you have a dirty filter with a lot of blockage, this will keep your pool heater from receiving an adequate amount of water. 

Take a Look at The Pool Pump:
If the pool pump is not operating with enough power, this can cause your pool heater to have issues. A lot of times, when you first install a pool heater, the pool pump may not be strong enough to bring water into the heater with an adequate amount of pressure. 

Inspect The Plumbing Valves:
Troubleshooting your pool heater can be as simple as inspecting the plumbing valves. While this may seem a little silly, if your plumbing valves are set in the wrong direction, then your pool heater will not be getting the necessary water flow. Doing a quick walk-through is of your plumbing valves and connections may lead you to find that an incorrect connection was made at some point. 

Source
https://poolresearch.com/


Pool Heaters Troubleshooting

Visa MasterCard

Site Secured By The Website Guardian
TOP