If you're looking for help fixing your Avanti Dishwasher, look no further! Our comprehensive Avanti Dishwasher error code guide will explain common issues, provide tips, and show you how to read your model's error codes.

Problem: Dishwasher does not start. 
Reason: Fuse is blown or the circuit breaker has tripped. 
Solution: Replace the fuse or reset the circuit breaker. Remove any other appliances sharing the same circuit with the dishwasher. 

Problem: Dishwasher does not start. 
Reason: Power supply is not turned on. 
Solution: Make sure the dishwasher is turned on and the door is closed securely. Make sure the power cord is properly plugged into the wall socket. 

Problem: Dishwasher does not start. 
Reason: Dishwasher door is not closed properly 
Solution: Close the door making sure the door latch is engaged. 

Problem: Water is not pumped from the dishwasher. 
Reason: Drain hose is kinked. 
Solution: Check the drain hose and ensure there are no kinks. 

Problem: Water is not pumped from the dishwasher. 
Reason: Filter is clogged. 
Solution: Check the filter assembly and remove any debris if any that may be blocking the filter. 

Problem: Water is not pumped from the dishwasher. 
Reason: Kitchen sink is clogged. 
Solution: Check the kitchen sink for adequate drainage. If the kitchen sink is not draining you may need to contact a local plumber to inspect your drainage pipe. 

Problem: Suds in tub. 
Reason: Improper detergent. 
Solution: Use only detergent specifically designed and marked for use with dishwashers. If this occurs, open the dishwasher and let the suds evaporate. Add approximately 1 gallon of cold water to the tub, close the door ensuring the latch is engaged. Select the "PRE-WASH" program. Press the Start / Rest button to drain out the water. Repeat if necessary. 

Problem: Suds in tub. 
Reason: Spilled rinse-aid. 
Solution: Always wipe up rinse-aid spills immediately. 

Problem: Stained tub interior. 
Reason: Detergent with colorant was used. 
Solution: Make sure you use detergents without colorants. 

Problem: White film on the inside surface. 
Reason: Hard water minerals. 
Solution: Wearing rubber gloves, clean the interior using a damp sponge with a small amount of dishwasher detergent. Never use any cleaners other than dishwasher detergent to avoid the risk of over-sudsing. 

Problem: There are rust stains on silverware / cutlery. 
Reason: The affected items are not corrosion resistant. 
Solution: These items are not suitable for dishwasher use. 

Problem: Knocking noise in the washing cabinet. 
Reason: The spray arm is knocking against an item loaded in the rack. 
Solution: Pause the wash cycle and rearrange the items accordingly to remove any item blocking the spray arm rotation. 

Problem: Rattling noise in the washing cabinet. 
Reason: Items are not loaded securely and are vibrating against each other. 
Solution: Pause the wash cycle and rearrange the items accordingly. 

Problem: Knocking noise in the water pipes. 
Reason: This may be caused by shaking plumbing or loose connections at cross-sections in the piping. 
Solution: This has no influence on the dishwasher operation. If in doubt contact a qualified plumber. 

Problem: The dishes are not clean. 
Reason: The dishes were not loaded correctly. 
Solution: See the notes in Loading the Dishwasher section of this manual. 

Problem: The dishes are not clean. 
Reason: The program selected was not the appropriate cycle for the condition of the dishes. 
Solution: Select a more intense program. 

Problem: The dishes are not clean. 
Reason: Not enough detergent was dispensed. 
Solution: Use more detergent, or change the type of detergent being used. 

Problem: The dishes are not clean. 
Reason: Items were blocking the rotation path of the water spray arm. 
Solution: Rearrange the items accordingly so that the spray arm can rotate freely. 

Problem: The dishes are not clean. 
Reason: The filter assembly in the base of the unit is not clean, is clogged, or is not installed correctly. (This may cause the spray arm jets to become clogged). 
Solution: Clean and / or fit the filter assembly correctly. Clean the spray arm jets. See the Cleaning the Spray Arm section of this manual. 

Problem: Cloudiness on the glassware. 
Reason: This is a combination of soft water and too much detergent. 
Solution: Use less detergent if you have soft water and select a shorter cycle to wash the glassware to get them clean 

Problem: Black or gray marks on dishes. 
Reason: Aluminum utensils have rubbed against the dishes. 
Solution: Use a mild abrasive cleaner to remove the marks. 

Problem: Detergent left in the dispenser cups. 
Reason: Dishes blocked the detergent cups not allowing them to open completely during the wash cycle. 
Solution: Re-load the dishes accordingly and re-run the wash cycle. 

Problem: The dishes are not dry. 
Reason: Improper loading,  
Solution: Load the dishwasher as suggested in the Loading your dishwasher section of this manual 

Problem: The dishes are not dry. 
Reason: Too little rinse-aid. 
Solution: Increase the amount of rinse-aid dispensed or refill the rinse-aid dispenser if empty. 

Problem: The dishes are not dry. 
Reason: Dishes were removed from the washer too soon. 
Solution: Do not empty your dishwasher immediately after the cycle ends. Open the door slightly so that the steam can escape. Begin unloading the dishwasher once the dishes are barely warm to the touch. 

Problem: The dishes are not dry. 
Reason: Wrong program / cycle selected. 
Solution: When using the shorter cycles/programs the washing temperatures are lower. This also lowers the cleaning performance. Choose a cycle / program with a longer wash time. 

Problem: The dishes are not dry. 
Reason: Using cutlery with a low quality coating.  
Solution: Water drainage is more difficult with these items . Cutlery or dishes of this type are not suitable for dishwasher use. 

Problem: The Start/Reset light blinks intermittently. 
Reason: Longer inlet time. 
Solution: Faucets is not opened, or water intake is restricted, or water pressure is too low. 

Problem: The Start/Reset light blinks intermittently. 
Reason: Overflow. 
Solution: Some element of dishwasher leaks. 

SOURCE: manualslib.com

Related Error Code Pages:
Avanti Dishwasher Error Codes, Avanti Dryer Error Codes, Avanti Microwave Error Codes, Avanti Range Error Codes, Avanti Refrigerator Error Codes, Avanti Washer Error Codes,

Related Troubleshooting Pages:
Avanti Dishwasher Troubleshooting, Avanti Dryer Troubleshooting, Avanti Microwave Troubleshooting, Avanti Range Troubleshooting, Avanti Refrigerator Troubleshooting, Avanti Washer Troubleshooting,

Related Repair Pages:
Avanti Dishwasher Repairs, Avanti Dryer Repairs, Avanti Microwave Repairs, Avanti Range Repairs, Avanti Refrigerator Repairs, Avanti Washer Repairs,

Related Parts Pages:
Avanti Dishwasher Parts, Avanti Dryer Parts, Avanti Microwave Parts, Avanti Range Parts, Avanti Refrigerator Parts, Avanti Washer Parts,

Related Price Pages:
Avanti Dishwasher Prices, Avanti Dryer Prices, Avanti Microwave Prices, Avanti Range Prices, Avanti Refrigerator Prices, Avanti Washer Prices,

Related Pages:
dishwasher quotes, emergency dishwasher repair near me, dishwasher installation near me, dishwasher replacement, dishwasher unit service cost,