Our Zline is a big hit in the kitchen. Everyone that has seen it wants one

Bought the zline black stainless microwave drawer to go in my center island. It is beautiful with white cabinets. Works great. The only negative is that it has had condensation every time I heat something, so I have to wipe the water out after every use. This may be due to ventilation in the island. The upside is my microwave always stays clean!

I am very pleased with this microwave. We were recommended it by a friend who is in love with Zline and all of their products and we thought we'd give it a shot. It is a very easy to use microwave with a mechanized sliding drawer and has an exceptional price to quality ratio. Highly recommended.

Received today. Make sure you are aware that this microwave is not a standard size opening. Although it is a standard width 24 inch (with a rough opening on 22 1/8 and overlapping sides to give some wiggle room), the rough opening height is 14 13/16, which is smaller than most. There is no overhang lip on the bottom and only a minimal 1/4 inch at most on the top so your maximum opening to not have gaps is about 15 inches. I had to use a 3/4 inch piece of cabinetry to fill the void. You can see it in the picture. It should be hidden by the counter overhang. Probably not an issue if you are designing your cabinets to accommodate this beforehand. Get the installation manual from Zline or find it only. Will update the function after using it but it is very nice looking and was extremely well packaged and a good value relative to other drawer microwaves.

A bit difficult to install. The door thickness plus handle is wide, and if aligned to the cabinet, it would have stuck out a bit from the countertop. Adding some cabinet trim on the inside of the cabinet frame, I was able to slide the microwave in a bit, and close out the opening. The door is slightly lower than the bottom of the microwave, so I had to shim the microwave to get the door to close. It works great and looks nice. Easy to use. Overall, I'm happy with the purchase. If I had to do it over, I'd probably buy a drawer microwave with a trim kit.