Appliance Types


Appliance Brands


Article Categories


More Articles


Keeprite Furnace Troubleshooting
Keeprite Furnace Troubleshooting

Keeprite Furnace Troubleshooting

If you're looking for help fixing your Keeprite Furnace, look no further! Our comprehensive Keeprite Furnace Troubleshooting guide will explain common issues, provide tips, and show you how to read your model's error codes.

Not heating?  
Possibly the electrical system that provides power to your furnace has shorted or blown the power switch. Reset your Keeprite furnace’s circuit breaker. If it is blown, you’ll have to replace it. 
The furnace’s igniter could be cracked or faulty. Check if the part has cracks. If it does, then replace the igniter. If it doesn’t, use a multimeter to test for continuity. 

Cycling irregularly?  
The thermostat of your furnace might be adjusting incorrectly. If your thermostat has an adjustable calibration scale, adjust the heat anticipator. If this does not address the problem or you don’t have a scale, you may have to replace the thermostat. 

Not blowing hot air?  
The blower motor may have burnt out. If this doesn’t seem likely, then the connecting belt may have broken. Test to see if power is reaching the motor. If it does, but nothing is running, the motor has likely failed and needs replacing. If the motor runs but air doesn’t move, the connecting belt has probably broken. You’ll have to replace the belt. 

Blowing too much air?  
If the relay that regulates the blower motor on the control board has failed, it will continually send voltage to the motor. Replace the control board. 
The contact that controls the blower motor on your thermostat may be stuck closed. The result is that the blower motor will run continuously. Use a multimeter to check for continuity. If the issue is the thermostat, replace it. 

Starting and then stopping shortly after?  
Your furnace’s flame sensor monitors the burner, detecting if a flame is present. It's either defective, or there is debris, and won't be able to detect a flame. If dirty, carefully clean the sensor using a fine abrasive pad. If not, replace the flame sensor.



Related Error Code Pages:
Keeprite Air Conditioner Error Codes, Keeprite Furnace Error Codes,

Related Troubleshooting Pages:
Keeprite Air Conditioner Troubleshooting, Keeprite Furnace Troubleshooting,

Related Repair Pages:
Keeprite Air Conditioner Repairs, Keeprite Furnace Repairs,

Related Parts Pages:
Keeprite Air Conditioner Parts, Keeprite Furnace Parts,

Related Price Pages:
Keeprite Air Conditioner Prices, Keeprite Furnace Prices,

Related Pages:
best deals on furnace units, high efficiency furnace, home furnace price, residential furnace system, furnace lowest price,


Keeprite Furnace Troubleshooting

Keeprite Furnace problems

Keeprite Furnace broken

Keeprite Furnace issue

Keeprite Furnace difficulty


Product Reviews:

My first furnace came with the house. As a result, when it started getting
My first furnace came with the house. As a result, when it started getting noisy and blowing cold air, barely one year after I moved in. I did not want to sink my money into something I knew little about. Consequently, after some research, I settled on buying the York TM9V. Its 96 percent efficiency rating meant that the upfront installation cost and purchase were a bit high. However, I expect to make great savings from the high efficiency of this furnace. It has been two great years with this furnace and it has no problems at all. I expect it to stay this way for at least another twenty years.
Published: November 24, 2020
pickhvac.com Little Egg Harbor, NJ
Source: pickhvac.com

This unit was actually installed by my aunt. On the winter of 2012, when sh
This unit was actually installed by my aunt. On the winter of 2012, when she installed it. Despite the house, being old and poorly insulated. This powerful furnace still managed to keep the house warm enough. My only regret is that I live so far away. As a result, I will not be able to carry the furnace with me.
Published: July 24, 2020
pickhvac.com Colorado Springs, CO
Source: pickhvac.com

A reputable company in my town installed the furnace; something I attribute
A reputable company in my town installed the furnace; something I attribute to its reliability four years after installation. The warranty terms were quite favorable, so I decided to take a full ten-year warranty. This has greatly contributed to the low running and maintenance costs. Except for a few issues, last year, which was covered by the warranty. The system has been running quite smoothly.
Published: September 24, 2020
pickhvac.com Augusta, ME
Source: pickhvac.com

This furnace has worked quite well for my three-bedroom house in Duluth. Ev
This furnace has worked quite well for my three-bedroom house in Duluth. Even in the middle of winter. I have seen a forty percent drop in my average gas bills since the system became operational. I have been using the furnace for seven years now. During that time, I have only had one crucial service call to replace the gas inlet valve. Thanks to my warranty, regular change of air filters have ensured the system continues to run efficiently.
Published: August 24, 2020
pickhvac.com Duluth, MN
Source: pickhvac.com

KeepRite has been keeping Canadian homes warm for more than 50 years, and i
KeepRite has been keeping Canadian homes warm for more than 50 years, and in that time they’ve earned a reputation for reliable and high-quality products. They have a range of models available depending on your needs, including more affordable standard-efficiency options with ratings of 80 percent AFUE and higher (though these are meant for the USA market), high-efficiency models with ratings up to 98 percent AFUE, and options for both gas and propane furnaces. Beyond that, each unit is tested before being delivered, and many come with a 20-year warranty on the heat exchanger.
Published: November 24, 2019
furnaceprices.ca
Source: furnaceprices.ca

Visa MasterCard

Site Secured By The Website Guardian
TOP