We have a lower end GE stainless steel model that came with the purchase of our new build home. The washer is just average and does not have a huge capacity. For only 2 people in the house it gets the job done in general.

Dishwasher lasted just little over a year when it broke down first time. Power switch made out soft plastic jammed up. Next cheaply made door close switch cracked. Part prices are average price. Because poor quality, I predict replacing this within 3-5 years.

Very easy to load. Controls are easy to read. Very quiet operating and does an excellent job cleaning utensils and all pot and pans. Have used for 8 years with no issues.

New house and all appliances came w/ it, used washer once to make sure plumbed correctly. It is the best storage container and no one looks in it... by not using it saved $38 a month in water bill and controlled water usage, throwing used water out on plants in drought, if need to sterilize put bleach in rinse water. I had 10 family members may have to use it other than for storage. Love to get a clothes pole for hanging laundry but God given rights of free sun and drying has been removed from us by associations. My machine is there if I need it. But great multipurpose and never complains... course after 13 years, crumbs in bottom and should run soon to clean it out... Its black and as this was a speculation home, builders chose colors... it doesnt show dirt as white appliances does... would buy same color again.. although real dark with oak kitchen.

Getting great service out of it. GE Dishwasher is a good unit for the money. Its does a really good job when loaded properly. I did just extend the warranty for another year. I am very happy with it.

We purchased a GE Adora Dishwasher less than 6 years ago from Home Depot. An unknown continual leak has caused substantial black mold, warped sub flooring and cracking of very expensive Saltillo tile of which weve had to remove. GE should be accountable and will be. Nearly, a $800 Dishwasher will cost us thousands in repairs and mold abatement. Unbelievable.

This machine washes glasses sparkling clean with the use of a rinse additive. I like the fact that it has a top, middle and bottom spray blade; it has a moveable silverware bucket; it is very quiet; it provides that you can wash the upper level separate from the lower level. It seems to make use of the maximum amount of space inside. The appearance is sleek and modern. During the first few washes there is a distinct heated rubber smell that emits from the machine; however, this should dissipate completely by the fourth, fifth or sixth wash.

Dishwasher is 3 months old and today is the first time it has worked! GE has sent repair techs 3 times and finally today the unit was temporarily repaired with electrical tape attached to the brand new door latch. The door latch is cheap plastic and has a manufacturer design defect of being too small to properly engage the unit when the door closes, thus not allowing the cycles to start just a series of beeps. No other manufacturer uses a cheap plastic door latch designed like this but GE! Piece of crap, dont buy it!

I have a 15 year old washer/dryer set that has worked consistently and it resides at a rental property. I purchased GE washer/dryer set for primary home 4 years ago and it's awesome. It's the level 1-2 steps above basic model and has enough settings to fit my needs (maybe more than I even use) such as pre-soaking, 4 settings for loads and much more. I would not purchase anything besides GE appliances. Very reliable and easy to interface with.

First impression was good but then went use it and found the basket was shallow. This was not a cheap one and was very quiet when running but multi loads have to be run. Overall the looks are good and the mechanics all are holding up fine. The smaller inside is the killer for me.

GE Dishwasher model #GDF610PSJ5SS stopped working (would not even turn on) a little over 3 months. Because it was purchased over a year ago for a spec home we purchased, GE would not honor the warranty even though we had only purchased the home 3 months prior. Repair, if possible, most likely would be more than buying a new one. Recommend avoiding GE products. This is our 5th home, never had problem with other brands in previous homes!

I love GE's washing machines front loader and it's excellent. I've never had to have them come out and four years to fix anything on it. Cleans very well and washes the clothes outstanding and it cleans up very easily when you clean it through the cycle that comes with the machine. It's relatively easy to understand as far as the button setup on there. I also liked that you get the echo warm in the Echo cold features along with the regular warm and cold. I did purchase the block that the time that I got it which helped out a lot is I'm 5 foot 10 and it's the perfect height. It helps getting stains out really easy as I have a nice here to play softball. I would definitely recommend this washer to anybody and everybody. I even wash my huge comforter for my bed in it and it washes it great every time.

Our washing machine has been with us for almost ten years and I really love the features which make it look modern and easy to dump in a load when we're running late for something. It has been having problems recently but it still runs okay, with only a few hiccups but for a little over ten years, that's pretty good!

It is functional and does the work. We are impressed with the large drum which takes a good load. It runs smoothly but with some noise. However we do not mind this as the end product is what we wanted.

This washer was easy to install myself, and has worked perfectly. Stainless steel insides. Very happy. You put a pod in, turn it on, cleans great. We do not even have to use heating element. Dishes dry quickly on their own. 24-inch wide. Bought to fit the new kitchen cabinets. Nice brushed stainless outside. Cleans easy with towel and hot water. Silverware container picks up to take to storage areas. No problems at all.

Just purchased a home with GE Appliances. Dishwasher suddenly wont start and showing 1H code. Nothing in the user manual that explains what this means. Called customer support. After they requested unnecessary personal information (like email address, physical address, etc.), I was finally able to ask what this code meant. She went straight to, We are unable to provide that information over the phone. We have to send one of our service technicians out to your home. She refused to tell me what the code meant, and instantly wanted to charge me for tech visit. I hung up. Then I googled it, and found out right away that it meant the start was paused/delayed for 1 hour. I had hit the delay button by mistake. This was not specified in the manual under Delay Start, nor was customer support trained or willing to provide the answer to such a simple question. GE Support is just a Scam.

I would not buy G.E. ever again! I remodeled our kitchen and have had more trouble with all the Appliances! They were all G.E. Frig, Microwave, Dishwasher and Stove and cooktop! Had to be serviced, all of them the first month!

We bought this GE Dishwasher through JC Penney with a 3 yr extended warranty in Dec 2017 thank goodness. I am on my 3 round of having the mother board and the heater replaced since I got this machine. This last tech came as a 2nd opinion for my claim that this machine has not worked more than it works. All we would do is load the machine, go to turn it on and out it goes. The warranty people sent out a GE Tech who ordered a new board and fuser kit and came to put it in. Same issue, he said it was my hard wiring and I should have a electrician look at it. 200.00 later not the hard wiring. It is a pin hole in the heater coil that this last tech found. New heater now on order. My faith that this will fix the problem is waning. After this my warranty will be up and I will Never buy a GE appliance again. Not worth the money.

Similar to another comment, we bought the entire suite. Dishwasher cycle screen gone after five uses. Oven temp needs adjusting. For the quality we were sold, this is extremely disappointing. Bought extended warranty, thank God, so will see if it was worth it.

I purchased a GE Dishwasher about two and a half years ago. Recently, we found there was a small leak in the solenoid motor which caused damage to my floor. I looked up for the model number and it is not on the recall list. Now, I have to call the repairman. This should have never happened in two years. What is GE going to do about this?

My GE Dishwasher is disintegrating. Its three years old and we didnt live here for a year of that time. The door where all the electronics just fell apart. I bought the most expensive GE Dishwasher I could find at that time because we wanted one that was quiet due to the way our house is laid out. We were able to put the door together again but the strip across the top never fit again so we taped it on. Model PDT750SSF1SS. The controls wont work.

28 Inch Front Load Washer with 4.9 cu. ft. Capacity, 13 Wash Cycles, 1250 RPM, Steam Cycle, Steam Assist, Time Saver Option, Sanitize Cycle, Energy Star in White. Overall this machine is top of the line. Purchasing a home appliance is like purchasing a vehicle. I took my time and reviewed and compared before purchasing. About 3 months. I had just purchased a home and so you want an appliance that is going to last. It has a 10 year warranty. It has 3 color options. It's cosmetically attractive. It also is elevated which is a smart choice for a basement machine in case you have issues with water in your basement.

Periodically my GE Profile Dishwasher will not clean well. On every occasion it is due to clogging of spray ports on the upper and/or lower spray arms. Removing the blockages is nigh-on impossible as it is often not possible to extract the blockage from the outside and its not at all possible to flush the blockage back down the arm to extract it at the centre. All that is required is a bit of forethought and the creation of some access to the arm. I was frankly surprised to not be able to find a replacement arm as the suggested solution to this problem, the additional part revenue being part of GEs the business model. There are a number of other design issues with the assembly at the bottom that make me think it was done by an intern and nobody checked her work at the end of summer break before it went into production.

I purchased a GE Dishwasher 3 months ago and it has been broke (wont drain) for almost a month. I tried to schedule a service through GE since it is under the warranty and they never showed up for the second time. I called and complained but it is not just the product, their service is even worst than the product. I am going to take the unit to Home Depot and ask for a refund or exchange with another brand. It is suppose to be brand new and wont drain or can we get a service scheduled. Never buying this brand again.

Purchased GE Dishwasher, Model GDF540HGD488. Its two or three years old and is junk. Top rack rails failing apart, bottom rack sliding rails have melted. Bottom sprayer has melted and wont stay on, incoming water has it bouncing on the bottom of the machine. As the heat dry is in it smells like melting or burning plastic. Dishes are NEVER clean and need re-washing. GE will do nothing, warranty off. Repairman says its just the type it is. Replacing it this weekend with a new Maytag, no way I would ever consider buying another GE product. Worst Dishwasher I ever owned.

Dishwasher broke after one year, just after the warranty period. The tech made two trips and couldn’t fix it, parts on back order for going on 4 months. Absolutely a nightmare experience along with rude customer service reps that want blame everyone else.

Entire inside is plastic crap. Dishwasher is very loud and takes a long time. Racks are ok but cheap feeling. If I was choosing, I wouldnt buy it. This GE was in new house. Overall feel is very cheap. Too much plastic. Very low end builder model. Steel inside or heavy plastic will take more beatings.

GE is a very reliable name brand with history to back it up. I’ve used their washing machines for years and only changed out once due to newer features. I had Thebes first washer for at least 10 years, maybe a little more. It only needed one part replaced, that was the capacitor, otherwise it was still usable. I am not an in depth handy person but I will read and do my research and found directions doable. Additionally, I found the service help desk very informative and that’s how I discovered it was the capacitor that had gone bad after washing clothes for so many years, and believe me, I did a lot of cycles with my kids and family. I feel I got more than my money's worth. Lastly, I’m still using their products to this day. I may not have the frequency because we are empty nesters but I still believe in their products,

Figure it out GE! The sixth motor and mode selector for our washer has been reluctantly ordered by a tech this morning. The second motor was installed months after buying the brand new machine. Now, only two months since the fifth motor and mode selector was installed (Dec 2, 2011), the wiring harness is burnt up. The tech recommends replacement of the washer by GE, but only gets push-back from GE. This newest incident included a horrific smell of smoke. I do not trust this machine. I have a wife and child to protect. Think about it - do the math - add your costs for repeated repairs. You do not get to be a company the size of GE by not understanding simple economics. Open your eyes and replace our washer.

Our GE Dishwasher is about 22 months old and is now not starting. GEs customer care is a joke. All they want to do is send a repair person with a $110 fee just to come and the person making the appointment refused to tell what the labor rate would apply once they got there. They offered zero help as far as troubleshooting. I called a local repairman and was told he has had many similar issues with newer GE Dishwashers. We are throwing parts at the problem now trying to get it running. He also said repair assistance or troubleshooting from GE is very poor. Really not pleased having a less than 2 yr old major appliance not working. GE means JUNK to me.

Front of door never seems to clean up well and its stainless steel. Occasionally if you use the start delay and a harder pod it can stick and not dispense fully during wash leaving a chunk of it. I love the ability to run half loads. Smartly designed, and easy to use.

I have a new GE profile model PDWT380VSS - Two in fact. The first one kept breaking glasses in the top rack. GE technicians could not find an answer so they replaced the Dishwasher. Now six months later its doing it again. This replaced a perfectly good, older model as part of a remodel. Theyll be sending another tech who I suspect will not have an answer. Any thoughts on what could be causing this or a way around it or is it to be expected? The first GE profile I had for several years with no such issues.